NC700X Lowering Kit

 

I install the centre stand and now is the lowering kit
The center to center distance of this kit is 15cm.
Tools needed:
1) hydraulic jack to adjust the rear wheel height in order to release tension on the link bolt. (this is not necessary if you have a friend to help you)
2) Hex wrench 14mm, 17mm

Steps:
1) Park the bike on road side over center stand such that the rear wheel will hang in mid air. There should be ~3 inch clearance from the ground.
2) Loosen the 17mm bolt on the exhaust pipe side. The 14mm bolt is still hard to be removed, because of the weight of the rear wheel.
3) Jack the rear arm with hydralic (any jack), till the 14mm bolt is free to be removed by finger.
4) The new link is longer and you have to jack up the rear arm further (1-2")  to align 14mm bolt.
5) Bolt in the 14mm bolt and 17mm nut. Secure with loctite.


20 分鐘
一人安裝, 要細jack, 17mm , 14mm 板手,
上大架, 泊在路肩讓尾6灕地
鬆死氣果邊2粒17mm帽
jack 起橫臂(1"), 直到條14mm 大螺絲可以用手指拉出
jack 高多1-2", 放入新狗骨及14mm 大螺絲
落藍色loctitie ; 上緊2粒 17mm 帽